Announcement

Collapse

Please DO NOT Post In The General Section

From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.


The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.


For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.


Everyone will get a couple of warnings from here on out, after that I just start deleting threads.

Again if you have any questions, PM me or one of the other mods.
See more
See less

How to convert to external coil?

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
    #1

    How to convert to external coil?

    I have a 92-93 external coil dist on my block. I wanna purchas this http://www.jegs.com/i/JEGS/555/40105/10002/-1 or the summit version of it to replace my coil. any thoughts? Oh yeah I checked OHMS on the coil and it wouldnt read A C terminals.
    Tags: None
    #2
    http://www.cb7tuner.com/vbb/showthre...highlight=coil
    later.
    Avoiding dirt at all costs

    Comment

      #3
      although its for internal coils Ill read a little longer and check the haynes eventually im sure ill find another way.

      Comment

        #4
        our coils have 4 wires to them opposed to 2

        Comment

          #5
          ^ EDIT the plug is set up for 4 pins but only uses 3 of them. I guess two of them are 12v and one ground. How should I install them on the ballast and coil ?

          Comment

          Previous template Next
          Working...
          X