Announcement

Collapse

Please DO NOT Post In The General Section

From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.


The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.


For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.


Everyone will get a couple of warnings from here on out, after that I just start deleting threads.

Again if you have any questions, PM me or one of the other mods.
See more
See less

Question bout cams

Collapse
X
Collapse
 
  • Page of 3
  • Filter
  • Time
  • Show
Clear All
new posts
Previous 1 2 3 template Next
    #31
    Originally posted by Losiracer2
    cams...hmmm I'm thinking about doing this since my A6 cam has some scoring on it, the machine shop guy said. I'm getting a 3 angle valve job done as well as new valve seals and stuff. Would a 272 benefit me? and where can I get them from? and how much do they usually run? i'm already in about 600 for this blown headgasket, so I don't have TOO much more money to spend.
    If you are not ready for a tune or some engine management system to compensate for the camshaft, then just get another A6 in better shape. Otherwise, it is pointless.

    Also, if you have cam scoring, if it was on the cam lobes, I'd have the machine shop look at your rocker arm pads.
    HondaFan81 For Sale Parts (LOW PRICES ON EVERYTHING)

    Comment

    Previous 1 2 3 template Next
    Working...
    X