I need some assistance w/ an Alarm/Remote Starter installation

[KRIS05VVTi]

I'm installing a (SCYTEK) Galaxy 5000RS-M module for a manual transmission in a 1993 Acura Integra.

I have most of it done but i was reading that for the remote starter feature to function i need a push button installed because there is a "process" that needs to be done before exiting the vehicle so that you can remote start the vehicle.

THE PROCESS:
- With the engine running i must be sure the vehicle is in the Neutral setting before continuing, then apply the E-Brake, push the remote starter button on the transmitter[remote], parking lights will flash twice after that is completed, turn off the ignition (motor should continue to run), push the Grounded push button button (siren will then chirp), open the door, step out of the vehicle, close the door and engine will shut down.

So after this process the vehicle will be ready to be remote started the next morning or what have you.

As for my question, How should i wire this "Push button." They have some in Auto Zone that has two terminals at the end. Should one side have a spade terminal connected to it and them grounded, with the BLUE wire (Turbo Timer Cancel Input) coming out of the alarm brain on the other terminal!? or how would you go about doing this?

NOTE: Any input will be greatly appreciated

[sonikaccord]

Where does the blue wire lead to? You may have to just put it in between the wire's source and target.

[KRIS05VVTi]

on another forum i got this....and it sounds logical:

the remote start feature for manual transmission does not use that input

that input is only to bypass the turbo timer when you want to remote start on a manual transmission.

anyways there 4 things you need:

1- Tach wire must be connected , The system must learn RPM.
2- Hand brake must be connected.
3- Door trigger must be connected
4- Clutch override installed

and all you need to do is wire the blue/orange wire accordingly (open circuit clutch switch) page 26 of the manual.

and this is the procedure for remote starting a manual transmission and putting it into ready mode:

With engine running and Hand-brake engaged put the vehicle transmission in neutral and remove the foot from the brake pedal,
press the remote start button on your transmitter, parking lights will flash twice indicating Manual Start Mode is enabled,
turn off the Ignition switch, the engine will remain running.
Open and close the door, the system will shut the engine Off.
Using the remote Control, Arm/Lock the vehicle.
Vehicle is now ready for remote start operation.

but now the thing is that the clutch is already bypassed

[KRIS05VVTi]

bump i still need ayuda

[bmxicansd]

bump i still need ayuda

hit up 2.2litrebeater..

[KRIS05VVTi]

thanx

[2.2litrebeater]

hit up 2.2litrebeater..

haha craig puttin me to work.
anyway there should be 2 wires.
green- goes to parking brake wire.
blue- connect to push button momentary switch, similar to the valet switch, and ground the other wire of the switch. thats it

[KRIS05VVTi]

4 post before your post does that matter?

[2.2litrebeater]

the blue wire is optional.

[KRIS05VVTi]

werd i just finished it and works great, but i did without the turbo timer cancel, that happens automatically after a procedure is dont to remote start it the next time you wanna get in the car

thanx for the imput