Lighting Question!

[life_shift]

Okay so what I was contemplating recently was to purchase fogs for my 91 ex. However I did not want to buy a separate light housing to place under the bumper turn signals. My conclusion was this, and here's where the question is. Is it possible to wire fogs into the turn signals?? The possible way i was thinking of accomplishing this was to tint the turn signals yellow, and use the wiring from the inside corner light and adding wire to reach the bumper signals and then retrofitting the fogs into the bumper signals. Is this all even possible ??

Thanks and God bless!

[agol]

Hey life_shift I would recommend buying a universal fog light wiring kit on eBay and if not that wire the fogs to your headlights fogs on a cb are engaged when the headlights are on so for the most oem look I would go for that !!!

[life_shift]

Hey life_shift I would recommend buying a universal fog light wiring kit on eBay and if not that wire the fogs to your headlights fogs on a cb are engaged when the headlights are on so for the most oem look I would go for that !!!

ok haha i will look it up haha thanks!

[sow3r]

there was a similar thread not too long ago, and people were saying that is not practical because bumper lights dont have reflectors in them, and that the plastic in the bumper lights its too soft and probably will melt if using h3 bulbs or something like that. try to do a search and you might find that thread, good luck!!

[mattman]

there was a similar thread not too long ago, and people were saying that is not practical because bumper lights dont have reflectors in them, and that the plastic in the bumper lights its too soft and probably will melt if using h3 bulbs or something like that. try to do a search and you might find that thread, good luck!!

true true.. you could always led it up, but wut would be the point lol

[life_shift]

true true.. you could always led it up, but wut would be the point lol

lol true haha well its either turn them in to fogs orrrr blackhouse them ive seen them done before but i cant find the thread for it. =/ i tried baking them open like headlights but that didnt work. does anyone know how 2 separate the lens from the housing??

[sow3r]

i dont think you need to heat them up, just take a flat screw-driver and pry the lens off CAREFULLY, and take your time, DO NOT RUSH IT, cause you might break the lens.