Alright I got on Majestic's site and was looking for the holding pin that guides the window on the rail on the 2 door. Do I need to get all those part numbers or is one of those a combination of them all.
Announcement
Collapse
No announcement yet.
window guide pin
Collapse
X
-
window guide pin
My Members' Ride Thread - It's a marathon build, not a sprint. But keep me honest on the update frequency!Tags: None
-
Actually, some one broke into my car by breaking my passenger window and the window I replaced it with didn't have one. So I need the whole thing. And my driver's side rattles like crap.My Members' Ride Thread - It's a marathon build, not a sprint. But keep me honest on the update frequency!
Comment
-
Originally posted by JarrettActually, some one broke into my car by breaking my passenger window and the window I replaced it with didn't have one. So I need the whole thing.
Originally posted by JarrettAnd my driver's side rattles like crap.
take off your door panels, windows up, carefully (very carefully) peel back the plastic on the end of the door (near the striker latch) and look into the panel at the run channel. if it's bare metal that's your problem. i'm pretty sure it probably fell out like mine did. there is also a black plastic clip that holds it in on the bottom. make sure to get that back on too.
after i did this to both doors, they shut just as quiet with the windows all the way down, as with the windows all the way up. it was the best two hours i ever spent working on my car so far. and when it was fixed, i was so
i'll post up some pics soon, not very descript, but my gf was taking pics when i was doing the work.
the bright spot (the trouble light) was where i found the rubber piece in the door. what im playing with is where the rubber piece goes up and meets the other run channel guide near the top of the door. in order to get the rubber up in there you will have to put pressure (a good amount) on the window, in towards the car. i would also reccomend using some clear silicone. i didn't have any around so i just used some super black gasket maker.
the rubber should just push in the rest of the way and then at the bottom the plastic clip holds everything in place. it can be a tight squeeze for people with normal sized hands, so you might get cut up a bit reaching in there and such.
i hope this helps, i feel like i just wrote a guide or something lol.
sorry if this is repeat info, i'm new here so i never checked to see if someone else wrote up something, which im sure has been done. but who cares, at least you dont have to go looking if you want to know. haha.
-scottLast edited by tweakit; 02-10-2006, 07:25 AM.
Comment
-
That helps a lot man. I'll go order those parts now. Thanks.My Members' Ride Thread - It's a marathon build, not a sprint. But keep me honest on the update frequency!
Comment
Comment