Ultimate engine bay/wire tuck sneak peak

[whitejdmcb7]

all i got to say is ILL shit is tight i cant wait to see it in person

[accord2nr81]

so this project has come along ways i remeber looking at the post when you started and it looks great mad props... how much you got in materials?
and you should make a DIY for all the wiring iam about to do my swap and not trying to byte your style but that shits Hot!
i would have to go ahead and do the firewall too scence your that far along

[turbo90accord]

I dont think im going to do the firewall overlaid but may create a flat panel to bolt to it.

Im going to try to document how i do the engine harness.

as far as materials i think im around 300 into the project but also nearly 300 hours into it as well. and i think at least 150 of the cost is in sand paper LOL. Would i recommend someone else do it? i dont know if you have the time and effort to do it its worth it. would i do it again? maybe but probably not. it doesnt look that hard to do till you have been sanding for weeks strait by hand because none of the curves are small enough to do it with a machine.

[mozzandherb]

Very nice work man! How many hours have you spent on it in total?

[drew12000]

looks really good! can't wait to see the tuck completely finished. take some high res pic so i can use it as my dt background! haha peace

[turbo90accord]

Very nice work man! How many hours have you spent on it in total?

Id say close to 300 hours

[turbo90accord]

amphenol connector wiring is a pain in the but with a POS 5$ soldering iron!

[zack_odom]

WOW. that looks a little challenging...

[turbo90accord]

WOW. that looks a little challenging...

its easy just time consuming

[steelbluesleepR]

amphenol connector wiring is a pain in the but with a POS 5$ soldering iron!

waitaminit, you bought a $100+ amphenol connector, and you're trying to wire it up with a cheap wal-mart soldering iron? dang, man, you're a masochist! j/p man, it looks completely awesome so far. i cant wait to see that amphenol connector done and in the bay!

[turbo90accord]

got my block on my stand, put my old head and IM on it to mock up harness.










got some bosch style injector harnesses so i dont have to deal with the crappy honda clip style... much easier to use.


View of top of motor and you can see how you cant see any injector wires.

[bacal36]

Thats tight man!

Just want to be part of this thread cause all your work looks like its well worth it!

Good job!

Paul

[topcop182]

all i got to say is ILL shit is tight i cant wait to see it in person

X2

[turbo90accord]

thanks guys!

[djphonics]

Aren't those Amphenol pins intended to be crimp-type pins? (As in you use some obscenely overpriced specific crimping tool from Amphenol to crimp them).