Sparco Grip Pedals

[Hondatuner998]

Does anyone know if there is any way to get the sparco grip pedal set to work on a CB7? I tried and it seems like the arm that the actual pedal attaches to gets in the way. Basically if you drill the mounting holes for these pedals you either are unable to properly attach the nut on the back of the bolt or u end up drilling all the way through the actual pedal and the arm the pedal mounts to. I'm about to sell these on ebay if i cannot get them to work. But i really dont want to because i love the look of them.

These are Them

[Hondatuner998]

anyone?? have anything to say??

[NAiL05]

Picture maybe? I was planning to purchase a set of these. You try off centering them a bit? THat might kinda work.

[maroonaccord2.2]

Drill some small holes (1/8"-3/16") and tap them. It really doesnt matter whether you hit the support arm in the back or not if you're not going all the way through. Then use some short machine screws (same thread as the tap obviously), a dab of blue loctite, and tighten them down.

DRILL

THEN TAP

THEN SECURE

[TypeG]

^^werd. later.