Front & Rear Bumper

[90accordman]

I'm Looking for a walkthrough for the removal and reinstallation of the stock bumpers.

I have decided to stick with the stock front and rear bumpers if i can take them off and adjust them. My front bumper is a little off to the drivers side and doesnt allign with my headlighs properly.

My rear numper looks as if the pre existiong muffler before i owned it melted it in one spot. If anyone knows where i can look for this information or let me know if its difficult to do, it will be greatly appreciated.

[h22sparkle]

As for the bumper make sure they are on tight and flush witht he metal you can have someone press em in and hold it when you screw them in. And watch out for the fasteners on the side with the little slider brackets on the side of the fender. Make sure there isnt anything blocking it or causing it to stick out being that it could be in the way.

About the rubber being meltd on the bumper i took a temper plated metal flat sheet i cut it out and flushed it neatly on the rear so it covers it up and used some hole punchers so it can stay on the bumper. It does wonders and resists the heat.

[90accordman]

Originally posted by h22sparkle
As for the bumper make sure they are on tight and flush witht he metal you can have someone press em in and hold it when you screw them in. And watch out for the fasteners on the side with the little slider brackets on the side of the fender. Make sure there isnt anything blocking it or causing it to stick out being that it could be in the way.

About the rubber being meltd on the bumper i took a temper plated metal flat sheet i cut it out and flushed it neatly on the rear so it covers it up and used some hole punchers so it can stay on the bumper. It does wonders and resists the heat.

I have since buying the accord replaced the muffler that was causing this problem with the rear bumper. The front i found a walkthrough on this site thats very nice but the rear im guessing ima have to trial and error it