motor mounts

[ap716]

i have a 10th anniversary accord. and i need to replace the rear motor mount.
1) I want to make sure that if i can get a lx/dx manual rear mount and braket and use it on my accord.
2) do i just block off the vacuum ports on the old rear mount?
3) any pointers on doing it?

[riceraccord]

The rear mounts are all the same for 90-93 lx/dx/ex accords the only difference is that the autos came with a vacuum operated dampener. If you have an auto just pull out the driver axle it makes it a whole lot easier to get at the bolts and remove it. If you have a manual you might have to take out the intermediate shaft as well as the axle but not sure on that one.

[ceelooboob]

The rear mounts are all the same for 90-93 lx/dx/ex accords the only difference is that the autos came with a vacuum operated dampener. If you have an auto just pull out the driver axle it makes it a whole lot easier to get at the bolts and remove it. If you have a manual you might have to take out the intermediate shaft as well as the axle but not sure on that one.

lx/dx manual rear mount is different than ex rear mount as well as the bracket....if you want to use an lx/dx rear mount on an ex you must get the lx/dx rear bracket.

[riceraccord]

lx/dx manual rear mount is different than ex rear mount as well as the bracket....if you want to use an lx/dx rear mount on an ex you must get the lx/dx rear bracket.

I thought all the mounts were the same because the engines and trans were the same. What is the difference between the lx/dx and the ex mount/braket

[prNonVtec4u]

lx/dx manual rear mount is different than ex rear mount as well as the bracket....if you want to use an lx/dx rear mount on an ex you must get the lx/dx rear bracket.

perfectly put

if i were you, i WOULD look forward to doing this change, then you'll have the option of running a stiffened insert and if you go the other route, i'll b easier/nicer to fill

[ceelooboob]

I thought all the mounts were the same because the engines and trans were the same. What is the difference between the lx/dx and the ex mount/braket

http://www.hondaautomotiveparts.com/...5=ENGINE+MOUNT

click that link^^^look at #3 and # 5 in the picture...#3 is ex rear mount #5 is the dx/lx rear mount.

[10thcb7]

How would you fill them in ?

[ceelooboob]

How would you fill them in ?

is use mcmaster liquid urethane 8644K18 thats 94a the hardest

[JohnD1079]

I tried to do that ^^^^^^^^^. Everything leaked out .

Buy ya the 10th AE has the vacuum dampened rear mount. Other than that i do not know except for lx/dx have the regular one. I dunno about ex, but i think it has a vacuumed one since its and "upgrade"

[ceelooboob]

I tried to do that ^^^^^^^^^. Everything leaked out .

Buy ya the 10th AE has the vacuum dampened rear mount. Other than that i do not know except for lx/dx have the regular one. I dunno about ex, but i think it has a vacuumed one since its and "upgrade"

automatic rear mounts use vacuum the 5 speed mount does not......yea in order for the liquid urethane to work you really gotta tape of one side really really really good.I also use the sand in the bucket...i just finished doing another set this weekend successfully...i have done like 3 sets of mounts....check that link out it explains step by step how to fill em.

http://www.energysuspensionparts.com...nt-Inserts.asp