cooling fans??

[johndenver120]

ok so after my swap my fans no longer work. i've checked my conections and all fuses. the temp on the cluster says normal but the engine is deff fucking hot after normal use. so hot that i dont drive it anymore bc im scared its gonna over heat.
not throwing code so wtf could be the problem. thermostat could i have forgot to hook some thing up??dont think so though!!

idk just upset bc im tired of this car being garaged!!!!

[9accord3]

take out the termo cut the inner part out leaving the outter shell with the gasket and put it back. dont know if you guys need the termo up there but in hawaii we really dont need the termostat. is your over flow boiling after a normal run?

[johndenver120]

bump... Its deff not the thermostat because i took it out and boiled it and it opened!!

fuses are good

changed the relay with the power window one and windows still work so its not the relay

only thing i can think of is that there a three plugs that went into the auto trans that im not using now thats its 5spd could these have something to do with it???

PLZ help

[C91BLX7]

bump... Its deff not the thermostat because i took it out and boiled it and it opened!!

fuses are good

changed the relay with the power window one and windows still work so its not the relay

only thing i can think of is that there a three plugs that went into the auto trans that im not using now thats its 5spd could these have something to do with it???

PLZ help

you could just wire your fans up to a switch

[johndenver120]

im really about to do just that because im stumped.

i jumped it from the battery and it works fine so its no the fan itself.

[NAiL05]

1. Recheck connections
2. Check Fan Switch
3. Turn on AC see if both turn on.

If its reading normal on temp gauge its good. There is nothing really to worry about...The fans dont come on unless needed...

[Fake Thug]

fan timer

[camdizawg]

it is not your thermostat. it could definetly being your tempurature switch, check your manual to see where it is located because i am not sure. but yea for the time you could hook it up to your ignition so it turns on with your key so you dont blow your motor

[johndenver120]

1. Recheck connections
2. Check Fan Switch
3. Turn on AC see if both turn on.

If its reading normal on temp gauge its good. There is nothing really to worry about...The fans dont come on unless needed...

yeah temp is normal on guage but the engine is deff too hot. AC fan doesnt work either and i'm gonna deff check the switch tomorrow!!!!

thanx guys!!!!


And oozingmachismo2 who can think of cars when looking at your sig!!! i'd love to see those in my mouth

[LinX]

radiator fan sensor is on thermo water housing

[AshesWagon]

not a good idea

take out the termo cut the inner part out leaving the outter shell with the gasket and put it back. dont know if you guys need the termo up there but in hawaii we really dont need the termostat. is your over flow boiling after a normal run?

well in our cars its not a big deal but with OBDII cars thats a serious no no. i dont feel like getting in to it but open loop and closed loop depend on thermo readings and even in OBD I or carb vehicles this is bad without reaching OPTIMUM temps your fuel mileage is gonna suffer and possible loss of power. im not your mom but come on its a 10 dollar part

[9accord3]

well in our cars its not a big deal but with OBDII cars thats a serious no no. i dont feel like getting in to it but open loop and closed loop depend on thermo readings and even in OBD I or carb vehicles this is bad without reaching OPTIMUM temps your fuel mileage is gonna suffer and possible loss of power. im not your mom but come on its a 10 dollar part




i agree my freind did that it worked i figure might help

[johndenver120]

yeah when i took out the thermostat i checked out the sensor and it looked brand new. i know that dont mean much though

if i warm up the car and put a continuity tester on the prongs will this tell me if its faulty???

[accordztech]

get a volt meter and confirm u have voltage at the fans, if u do then its the fan. if u dont then it can be those 3 things by ur power steering pump, 2 of them are relays and i think the middle thing is too.

that was why my dads wasnt working, one of the silver oens in the rubber thing was bad...cheap fix...no ghetto riggin or doing something weird like takin out thermo.

ever thought about checking fuses as well?