Hi guys!
Ive just finished my H22a swap, but Im getting codes 6 and 20.
I have tried to change my temp sensors(code6) from the old motor, but Im still getting the code... Is there anything else I can try before buying new ones?
But, here is the big problem: I found out that the ELD(code20) was located in the fusebox, but when I opened it up, it wasnt there
there was only an empty hole...
Is there anyway I can get the ECU(p13) to belive its getting the signal the ELD would normally give?
Anything helps
-Tommy-
Ive just finished my H22a swap, but Im getting codes 6 and 20.
I have tried to change my temp sensors(code6) from the old motor, but Im still getting the code... Is there anything else I can try before buying new ones?
But, here is the big problem: I found out that the ELD(code20) was located in the fusebox, but when I opened it up, it wasnt there
there was only an empty hole...Is there anyway I can get the ECU(p13) to belive its getting the signal the ELD would normally give?
Anything helps
-Tommy-
Comment