i bought a P06 ecu and tried the DIY Chrome basemap for an F226 engine...created about 10 different basemap and everytime i burn the chip and connect the ecu up to my car...another dissappointment after another...the check engine light stays lit and i can only rev the car up to 4500 RPMs...
im using free Chrome software...27c512 chips...and the LS map...i have disable most sensors and such...but same problem occurs...
my car mods are: K&N intake...4-2-1 headers, highflow cat, 2.25 pipe, and cherry bomb muffler...full MSD setup w/ SCI-ingnition...
i was wondering if someone:
1. can give me suggestions
2. give me a basemap for a f226 engine
yada yada yada...
HELP ME!!!!!!!! THANKS
im using free Chrome software...27c512 chips...and the LS map...i have disable most sensors and such...but same problem occurs...
my car mods are: K&N intake...4-2-1 headers, highflow cat, 2.25 pipe, and cherry bomb muffler...full MSD setup w/ SCI-ingnition...
i was wondering if someone:
1. can give me suggestions
2. give me a basemap for a f226 engine
yada yada yada...
HELP ME!!!!!!!! THANKS
Comment