Rear Toe Adjustement Bolt Broken

[dwhacks]

So my brother and I put the CB7 on the alignment machine and went to adjust the rear left toe. Looked a bit rusty so we lubed up the bolt but it broke off anyway. We can't seem to find a replacement or part number. Haven't tried calling Honda yet, but I guess thats the next step.

It is the bolt on the rear front control arm with an eccentric head/washer to adjust the toe. any help would be great!

[Fleetw00d]

http://www.hondaautomotiveparts.com/ is your friend for finding Honda part numbers. I'd give you the part number, but the site appears to be down at the moment.

Found it on another site:

31 52387-SE0-023 Bolt, Arm Adjusting (Lower) USA 2 $15.63 $11.26
32 52388-SE0-030 Plate, Cam USA 2 $3.95 $2.84

[dwhacks]

Thanks, the site is back up and I am able to find it. They don't have a very descriptive name for it; "lower arm adjusting bolt".

I will see if I can find a "kit" of sorts from a local supplier, I guess those part numbers are good for them to use to look up parts right?

Part number 31 here

[deevergote]

Those are Honda part numbers, yes. Should be able to search for them, or even ask for them at a local Honda parts counter.

[Fleetw00d]

Thanks, the site is back up and I am able to find it. They don't have a very descriptive name for it; "lower arm adjusting bolt".

I will see if I can find a "kit" of sorts from a local supplier, I guess those part numbers are good for them to use to look up parts right?

Part number 31 here

The eccentric washer at the bolt head is part of 31. Part number 32 is a special eccentric washer for the other end (it has two flats just below the threads so that item 32 will rotate when the bolt rotates, check that the hole in yours is not completely rounded out. When you install them, tighten by turning the nut ONLY.

[dwhacks]

Right on, thanks for the info. I should have this sorted in no time!