mild wire tuck, problem with wiring?

[PurpleDinoRhino]

I plan on it as soon as I can get the new brake lines, master cylinder, and prop valve, but yeah its not wheel related then, and car starts now, starter wire from the battery was loose, and I'm about to try and fix the brake lights

[cb7 calling]

Maybe its the brake lamp switch on the pedal. How is your voltage?

[PurpleDinoRhino]

Okay, so I tested the brake light swotch , and the white/yellow stripe wire is not getting power?

[PurpleDinoRhino]

Okay the switch isn't getting power, where does the white/yellow wire go? I know the green and white wire goes to the back lights, and the white/ yellow supplies voltage,

[PurpleDinoRhino]

Alright, everything thing is fixed, it starts, and has lights now, but when it is running, it runs at 10v, and as I give it gas, and drive, the voltage drops to 8, and the radio goes in and out of protect mode still, so i gotta start checking all the wires starting at the battery right?

[preyes86]

Does anyone know someone who does wire tucks in the Houston area?

[PurpleDinoRhino]

Okay everyone, I checked the wiring, the headlight harness for both sides are fine, everything is sealed off, the fusebox wiring is the same, its all fine, my battery cable to the fusebox is fine, same with the starter cable, I can JumpStart my car, but after disconnecting the cables the voltage drops too 11, then slowly drains, and eventually the car dies. I can't find any shorts and I've went over the wires, the battery is only about a year old, alternator checked out fine.

[cb7 calling]

Maybe alternator. I would unhook it and start the car and check the voltage.

[Accord1320]

Maybe alternator. I would unhook it and start the car and check the voltage.

I would've said the same thing. Damn it, calling, you beat me to it.

As far as your exhaust smelling up of gas (running rich), check your spark plugs (if it's black) and consider replacing your o2 sensors if it's all black (faulty o2 sensors will send a false signal to your ecu and cause it to run rich).

Check out my install videos on my youtube channel and see if you ran into some problems like I did. I had jacked up injectors and had to have them serviced by RC Engineering, changed my spark plugs to copper ones, and replaced o2 sensors. Not only that, my MAP sensor wiring was mixed up, causing it to stall and die when letting off the gas pedal...

The price I paid for an H23A swap...