Pissed, sudden oil leak.

[otto07]

i will pull it tomorrow and see.

Did you throw the homeless guy a few bucks in thanks? Dude may have saved your engine.

the homeless guy ran across the street to make the light before traffic started going again.

[h22sparkle]

See how bad the engine is first before you do a swap. And atleast make sure when you do the swap make sure that you do the complete swap.

[otto07]

i know i am. im trying to take every step possible to make sure my engine is fine and that it can be repaired.

if i have to do a swap it will be a h22 from hmotorsonline with a lsd transmission. complete swap of coarse.

See how bad the engine is first before you do a swap. And atleast make sure when you do the swap make sure that you do the complete swap.

[deevergote]

You don't really need the "complete swap". I did that, and I have a basement full of wire harnesses, axles, etc... that I'll never use! It WAS nice to know that EVERYTHING came with it, though. Even if it was too much!

[otto07]

oo really? ill have to look over the parts list then and make some decisions if necessary.

[dj_ender]

It's tomorrow.......

[otto07]

i know im at work for another hour and a half.

after that its time to get to work. i will be sure to get that cover off tonight.

the only bolts holding the cover on are the 2 on the side of it right?

It's tomorrow.......

[dj_ender]

i know im at work for another hour and a half.

after that its time to get to work. i will be sure to get that cover off tonight.

the only bolts holding the cover on are the 2 on the side of it right?

Yes. And you will either have to pry the lip from under the valve cover, or remove the valve cover completely to get the timing cover off. I prefer to pry the lip out from under the valve cover, takes less time.

[otto07]

i don't have the proper tools at the house today. I did not know that i have to remove the motor mount to access the bottom bolt.

[dj_ender]

i don't have the proper tools at the house today. I did not know that i have to remove the motor mount to access the bottom bolt.

You don't, use a short 10mm wrench. Takes awhile, but it will get the job done.

[otto07]

i have every other wrench other then a 10mm. tomorrow i will have all the tools i need. it looks like all the oil came out of the bottom of the cover so i am hoping it is that seal.

[dj_ender]

i have every other wrench other then a 10mm. tomorrow i will have all the tools i need. it looks like all the oil came out of the bottom of the cover so i am hoping it is that seal.

Your saying theres a pool under the section I mentioned last night?

[otto07]

not a pool but it is covered in oil. ill grab a pic 1 sec/

[dj_ender]

not a pool but it is covered in oil. ill grab a pic 1 sec/

No need, that confirms it's one of the seals I mentioned.

[otto07]

meh took pics anyways.