Just. Installed h&r springs on the fronts. And now the passenger side makes a clunking noise when I drive and go over bumps. When I push down on the car I don't hear anything tho. Any help?
-
-
If you had done the work, go over your own work. Look for loose bolts, sign of wear and such.
If you had some one do the work, take it back to the person.A&P-IA -
my cb7 did this until i replaced the shocks. i put new springs on bad shocks and it would clunk everytime..i would check them out, bc mine stopped after i replaced them.Comment
-
Ya this is generally from a strut being dead. I have one on my passanger rear. I live with it, because it is not too loud but could be wise to replace it..... someday."There is nothing wrong with you that an expensive operation cannot prolong."Comment
-
Did you really changed to shorter/other springs without changing struts with new? If the struts were bad, it is relatively easy to notice that, too.A&P-IAComment
-
it could also be bad ball joints.Originally posted by cb_Mi3nsleeper View Postthis was put together by evil_demon_01 . You can also fined all this and more by him in the Common Beginner Technical Info can be found in here. PLEASE READ HERE FIRST
Not this one though.1990 to 1993 accord fuel psi .
Car safety checks
Diagnose a Check Engine Light (also S/D4 transmission error codes)
How to Set Base Idle Properly (F22ax, F22bx)
Cheapest Suspension Setup to Lower Your CB7
Fluid CapacitiesComment
Comment