Hey all,, yesterday my car failed to pass the annual re inspection bcaz of the brakes, i changed the Fr Brake Pads and the Rear Brake Shoes ,, but the rear Brakes and the parking brakes are not good at all, the front rotors are already worn out so i bought the New After market front rotors Made in Taiwan ,, shud i go for the after market rotors?will take the rear drums to the machine shop for a slight tool, the brake pedal doesnt do anything weird, but it viberates on high speeds,the master cylinder is not leaking at all,, shud i change it or not? the pedal never goes down to the floor,,if i press the brakes hard, the car doesnt stop like the way it should b,, what to do? after market rotors are good or not?shud i change the drums as well?or will the machine shop do the trick?what symptoms are there for a weak master cylinder? and ofcourse the proportion Valve,,?what to do?
-
-
Since the rear are drums, just replace the shoes with new ones.
If you changed out the front pads and rotors already, make sure you bleed the brake lines so there isn't any air in the lines.
That should solve your braking issue.
And check to see if you have enough brake fluid.
If its low, check for leaks from the brake lines and replace the necessary ones, and bleed the brake lines. -
no i havent changed the brake rotors, i have got rotors made in taiwan and was doubtful about them if they are gonna work fine,,,? i will put the rotors in today and will change the master cylinder as well,,, once in for all,,,and will tool the rear drums and will see what to do next,,in re inspection, the front brakes have had the grab of 3 %, rear brakes were on 2.5 % and the parking brakes were on 0%,,,Comment
Comment