F22Ax Velocity Stacks/ITBS

[JDMDaniel240]

Yea man, I remember it like yesterday. You need the full setup though- H22/H23 plenum + TB, A6 runners, A6 cam, PT6 ECU & the ECU controlled IAB black box (basically a stock A6 w/the H22/H23 plenum + TB). I like to keep the exhaust relatively quiet cause they drone

F22A6 Intake Manifold are the ones that have the IAB right??? or should i just get an h23 instead. also would it being any good getting a h23 throttle body or no

[gloryaccordy]

F22A6 Intake Manifold are the ones that have the IAB right??? or should i just get an h23 instead. also would it being any good getting a h23 throttle body or no

What engine/ECU do you have?

Best bet, just get the whole H23 IM. And yes you need the TB, your F22A TB won't fit. Def should also get the black box, and if you can the PT6 ECU

[JDMDaniel240]

What engine/ECU do you have?

Best bet, just get the whole H23 IM. And yes you need the TB, your F22A TB won't fit. Def should also get the black box, and if you can the PT6 ECU

I have no idea what ecu i have all i know is that it is a F22A1

[deevergote]

Then you have the PT3 ECU. That's what controls the F22A1 and F22A4.

[euraphex]

Does any body know where can get some custom Velocity stacks or ITBs for and F22Ax that cost less than $500 cause i cant afford Bisimotos And + they cost more than my cb7 lol

http://image.superstreetonline.com/f...gine_block.jpg

Sorry to tell you but any performance mods that you will do will probally cost more then the car. Hell i just ordered a H22a with LSD tranny for my cb7 and it costs $800.00 more then what was paid for the car. But already spent the money on whole new a/c system besides blower motor. I have had issues from wheel bearings, brakes, water pump, timing belt and the F22a still blew.