h22 rods n piston in a f22

[wed3k]

get a reall powerful hose or pressure washer and blast the inside of the port and see if water comes out the combustion chamber.

or pour water in the CC and blast the port with compressed air and look for bubbles.

what id do is just bring it to a machine shop and have this guy Wes check it out.

[cb2slo]

He's referring to chessboxer... rather than letting it go to someone else, he should have just let it go to the crusher (though it was in good shape when he parted ways with it...)

IMO, it's just too difficult to part with a beloved project as-is. It'd have been better parted out. It's also never smart to buy someone else's project, unless you know what was done to it every step of the way. Problems like this are the result of buying a secondhand project car. The buyer never cares for it as much as the builder... and the second buyer usually ends up getting the stinky end of the stick.

I hope you can bring this car back to life. You'd have your work cut out for you if you knew what you were doing... Knowing as little as you do, it's going to be QUITE a challenge. Not impossible, but it's going to take a hell of a lot of work, both to learn what you need to know, then to do what needs to be done.

I hope you didn't trade a solid CB7 for this car. It'd have been cheaper and easier for you to boost your old car than it will be to thoroughly rebuild this one. The good news is, once you've finished bringing this car back to life, you'll know a hell of a lot. You'll be telling ME what to do, because this is going to require you to do things that even I have very little knowledge of. (not that I'm an expert... far from it, honestly)

all i can do now is read up n start getting parts...stupid question when can i start looking at the for sale stuff? do i have to be a member for a certain period of time or something?

[deevergote]

Check out the Rules section... everything is explained there (and the rest of the rules will be useful to know, so you don't get yourself banned...)

[chessboxer]

I'll do you a favor and give you $1500 for it as it sits. Save you some headache.

[cb2slo]

alright guys im back again with ya guys help as ya know i traded my perfectly good cb7 for another cb7 that was boosted an a couple of days later i fried my rings/ blew my motor. an i just got my motor out a couple of days ago i still dont know what the problem is with the motor that came out yet but i have another bone stock motor that ready to go in an my problem is that i dont have a wiring diagram an idk were to get one at can any one help me out on that? also the car has a haltech ecu thats tuned for boost would that give me any problems?

[PR CB7]

thats it, once i get tired of my car, its going to get burned and crushed
this will always be your car

[chessboxer]

It will give you loads of problems if you try and run an n/a motor on that tune.

Sell me the car.

[cloudasc]

Oh snap, looks like chessboxer is trying to get back in the game