Electrical issues!!!

[Isdoyra]

Well, to make it short, I'm having trouble with the white and green wire that goes into the alternator regulator socket.

I've already replaced in the Alt, the bearings, the brushes, the stator, the rotor and the regulator, I mean it's fully rebuilt.
So I went to the manual and tested it, and to my surprise the S terminal does not have voltage.
The manual says it could be an open in the wire or fuse number 21 blown, but that fuse it's not used, so?



According to the manual it should throw voltage, but it doesn't, then I go following the wire and in the middle, under the TB it throws half of the voltage.
i'm tired and testing that is a bitch, any sugestions what could it be? what can i do?

[JDMDriver]

I say buy a replacement from the JY to get it running again.

You can use the JY to compare with your current one.

Move away from it for now as being tired and frustrated is a no no to fault finding. When you come back with a fresh mind and approach it may jump at you... believe me how many times this has happened to me (for work it is also a good advise).

Once you fix this you can have it (or the one from the JY) as a back up so either way the one from the JY will not be a waste.

Go get one and compare.

[Isdoyra]

Thanks, I stopped when I created this post, so Im gonna start tomorrow again, finally I think that if I change the wire, I would solve the problem, hopefully. Thanks again!

[Isdoyra]

seems like regulator got burnt again, aghhh the fuck with electric things, dunno what to do.
Well Imma take it to an elevtrician next week!

[wed3k]

run a new wire and see if it helps. it's probably dropping voltage somewhere.

[Isdoyra]

run a new wire and see if it helps. it's probably dropping voltage somewhere.

I did, and it didn' help, tomorrow I'm gonna buy a new regulator an run the wire again
!!!
Thanks for reading and answering!!