Strange Problems with cb

[91@CCORD74]

for the longest Ive been throwing code 8 for the tcu which means coolant temp sensor. Ive replaced every temperture sensor on the engine, took the harness aloose looking for shorts but never found anything so I gave up, but this is what is going on.

1. Throwing tcu code 8
2. Car idles at 200 when cold
3. Hard to start when sat for a few hours even if its hot/cold outside
4. steering wheel drifts right when i accelerate
5. All tires balanced and new but shakes at 70 mph

edit: number 3 was eitha dizzy, or water in sparkplug hole, anyway i fixed those and it doesnt do it anymore

[Reignstarz]

for the longest Ive been throwing code 8 for the tcu which means coolant temp sensor. Ive replaced every temperture sensor on the engine, took the harness aloose looking for shorts but never found anything so I gave up, but this is what is going on.

1. Throwing tcu code 8
2. Car idles at 200 when cold
3. Hard to start when sat for a few hours even if its hot/cold outside
4. steering wheel drifts right when i accelerate
5. All tires balanced and new but shakes at 70 mph

4. steering wheel drifts right when i accelerate - Alignment
5. All tires balanced and new but shakes at 70 mph - Bushings and or sway

[CAMILOSI]

Code 8 is tdc sensor-top dead center position if it's that then u're going to need a new dizzy, but if it's code 6 then that's u're ect sensor the one u said u replace.

Why u don't recheck ur code to make sure u go after the right one.

And if it's code 8 that explains your 1-3 issues.And about the drift when u accel it could b due to torque steer but check your alignment to make sure.And about the vibration u could balance a square rim and it'll come out right if u already balance them all then it could b a bent rim.

[RagingAsian]

for number 2: is your CEL on?

[91@CCORD74]

Code 8 is tdc sensor-top dead center position if it's that then u're going to need a new dizzy, but if it's code 6 then that's u're ect sensor the one u said u replace.

Why u don't recheck ur code to make sure u go after the right one.

And if it's code 8 that explains your 1-3 issues.And about the drift when u accel it could b due to torque steer but check your alignment to make sure.And about the vibration u could balance a square rim and it'll come out right if u already balance them all then it could b a bent rim.

read closely man I said Tcu not Ecu

4. steering wheel drifts right when i accelerate - Alignment
5. All tires balanced and new but shakes at 70 mph - Bushings and or sway

thanks man ill check that out

for number 2: is your CEL on?

no cel