my turbo f22a build

[realxfresh]

if only i had the money for a turbo build.

[boostdelinquent]

http://www.xenocron.com/3-bar-map-se...-gm-p-195.html

[coupe]

thanks ppl. more pics coming soon. i finally talked to hedy at bisimoto today and they shipped my cam, headgasket, and valvesprings this morning. so i am hopeing to have the motor together this weekend if my stuff gets here on time. and if so i plan to r and r the motor monday. i will update asap. thanks guys

[LoDollar92LX]

just an FYI, H23 rods work in a F22 with no mods. lots of options there for H23

[boostdelinquent]

Your build is coming along very nicely. How soon after you have the engine broken in, do you intend to go to the dyno and have it tuned?

[coupe]

i wish i would have known about the rods before i put my bottom end together. lol but it is to late now. i plan to be on the dyno begining of may at the latest. but i pulled the motor out today, so i am just waiting on my stuff from bisi. and i can put it together. i picked up my ecu last night. but i will keep yall updated. thanks for the replys

[DejectedAngel]

Nice man those are my exact plans when i get my cb7 and the exact car i want! Where did you get your 16g turbo from?

[coupe]

i got it from a guy on my local forums. and i am rebuilding it. i got everything off the old motor. and i got some purple power. i am about to go to town on it. and the engine bay. i want it as clean as posible. so i can spot any leaks once i got it back together. hopefully none but just in case.

my tracking number is finally working.(from bisimoto) it has been rescheduled to be here monday, so needless to say it the motor wont be in monday. but hopefully i can get out of work in time to get the motor in it sometime next week.

[DejectedAngel]

Nice man good luck with spotting on the leaks hopefully you get none.! How much you think your pulling now with the 16g set-up?

[hardcorepunkme]

sweet build man kinda what i had in mind....time to pull on those h22's

[jas_r34]

great build, cnt wait to see some numbers. Take sum vids too when ur on the dyno

question about the 3 bar map sensor tho, y do you need that if your chipping/tuning your ecu? I havent heard of anyone whos turboed getting that item

[boostdelinquent]

Even when you chip and tune the ECU, you still need imput from the MAP sensor for the calibration as it monitors the amount of incoming air. The stock MAP wasn't intended for boost and only reads up to 12lbs iirc.

[drummersteve7]

and again as previously stated..epic fail on the pics...

Im assuming you just want attention at this point.
I have no faith you are actually doing this.

get some pics up of the engine bay not the front of the car please!
hehe teasing everyone and you suck for it!

[coupe]

lol aight i am going to the shop today. it is my day off. i will try to get some better pics of the whole car. yes i am still waiting on my cam and headgasket and valvesprings. supposed to be here today. when they get here im goin to put it all together. but thanks guys for the replys.

[VCB7]

Cant Wait :d