how do i change h22 tranny fluid ?

[ibr_adam09]

if it requires a change , then i want to do it

its a manual so shouldn't it be similar to changing engine oil

also what tranny fluid do i use and filter ?

[swanrugbycb7]

umm ya its basically the same except theres no filter. u need a 17mm wrench and i would suggest royal purple tranny fluid.

[Father Time]

also what tranny fluid do i use

Honda MTF

[Jonas]

gm synchromesh is good too


theres a drain plug. 17mm or maybe even a 3/8 socket hole that you put your ratchet directly into. i forget. you refill from the top. need a funnel with a long hose on it to do it. no dipstick. it takes like 1.8 quarts or something. a little under 2

[ibr_adam09]

does auto zone or advance have the honda mtf, if not where do i get it ?

[DaGrk1]

does auto zone or advance have the honda mtf, if not where do i get it ?

dealer

[zacatecas]

whats the excact measurement on how much to add when you change the tranny fluide.drain and fill.i use ATF tranny from dealer

[C91BLX7]

whats the excact measurement on how much to add when you change the tranny fluide.drain and fill.i use ATF tranny from dealer

ATF doesn't work so well in a 5spd.

[zacatecas]

ATF doesn't work so well in a 5spd.

how about AUTO

[Father Time]

how about AUTO

ATF is Automatic Transmission Fluid

Not being a ass but just making it clear for anyone else. That's all.

So to answer you question. ATF would would great in an auto tranny.

[oneoffaccord]

what i do is raise the left side, while draining the oil. then when its done, lower left side. raise right side. then refill. thats how i do it, get it all out. easier to fill also.

[GangstaCB7]

Ok, so exactly how much fluid for the 5speed H tranny?

[H23CB7]

its damn near right at 2 quarts. If not its like 1.9. I lift the right side when filling and all 2 quarts goes in. Go with honda MTF from the dealer. It's like 6 bucks a quart

[BLUBB2]

yes you are right.
1.9-2.0 quarts it is.

[The G-Man]

gm synchromesh is good too


theres a drain plug. 17mm or maybe even a 3/8 socket hole that you put your ratchet directly into. i forget. you refill from the top. need a funnel with a long hose on it to do it. no dipstick. it takes like 1.8 quarts or something. a little under 2

jonas, you are retarded. It is a hole only for a 3/8'' drive ratchet. Then the 17mm above that is the fill hole.

I have seen people fill through the vent hole, vehicle speed sensor, and even take off the shift linkage to fill it up.