so about 4 months ago i got my whole front left side redone. upper control arm, tie rod end, ball joint and bearing. i did this cause i hooked a curb pretty good, so my other side was still good.
well now its come time to do the other side, and i was wondering, would it be better to get the same parts, or does it not matter which brand i get. cause some things i went higher quality then other, like control arm and ball joint i cheaped out on, but bearing and tie rod end i got high quality.
cause theres this place that sells parts real cheap, but i figure im only going to tuff this car out till next summer so i was leanign towards cheaping out on everything. what are your thoughts?
well now its come time to do the other side, and i was wondering, would it be better to get the same parts, or does it not matter which brand i get. cause some things i went higher quality then other, like control arm and ball joint i cheaped out on, but bearing and tie rod end i got high quality.
cause theres this place that sells parts real cheap, but i figure im only going to tuff this car out till next summer so i was leanign towards cheaping out on everything. what are your thoughts?
Comment