F22A4 header

[ofr]

Ok im wondering if my 02 sensor would reach down to the down pipe where the F22A4 header has the whole for it. i have a F22A1.

[ExplodingCake]

No it won't , you need to do an extension.

[ofr]

No it won't , you need to do an extension.

ok thanks.

[cb7sk8rdude]

how long of an extention did you need to do?

[dj_ender]

Now I could be way off base but I thought that the o2 sensor leads were supposed to be a certain length, and if you lengthened them the signal would be messed up. Like I said, i could be wrong.

[deevergote]

In theory, altering the wires in any way (lengthening, splicing, soldering...) COULD have a negative effect on the sensor's effectiveness.

Other options include:
Getting a new o2 bung welded where the original location was
Making a subharness (this may or may not be a better option than splicing)
Swapping the wiring harness for an EX one.

[dj_ender]

In theory, altering the wires in any way (lengthening, splicing, soldering...) COULD have a negative effect on the sensor's effectiveness.

Other options include:
Getting a new o2 bung welded where the original location was
Making a subharness (this may or may not be a better option than splicing)
Swapping the wiring harness for an EX one.

Cant you just find the O2 leads and pull them out of the wire loom of the harness and "make" them long enough? I would think this would be the best option, if theres any amount of length you can gain by doing this.

[Rhonda]

I'm pretty sure you can just get a different O2 sensor for a different trim level.

Don't know which trim that is though....