What size volt do I need to put on a front lip

[Bruce Banner]

I got a CD5 lip I'm looking to attach to my 93 Lx.
What size bolt do I need?
Are holes already in place on the bumper?

[n4red]

There should be bolt holes already in the new lip and you should be able to reuse the bolts from the lip that is currently on your car. If you don't a lip on the car now then i suggest using self-tapping screws and maybe some screw clips. You should be able to find these at a hardware store.

slide the clips over the end of the bumper, then with the lip held up against the bottom of the bumper use the self-tapping screws to screw through both the lip and the bumper until the screw pulls tight on the clip.

[Bruce Banner]

I have an LX, there is no existing lip

[Bruce Banner]

bump

[Bruce Banner]

anybody?

[djcb]

hey bruce, get some 10mm self threading screws and a drill, start at the middle of the bumper and make it fit

[Bruce Banner]

Is there a certain length I should look for?

[NAiL05]

Wood screws and drive them in the bumper. Length whatever you think is a good size.

[dynamite]

did the ex accord come with a stock lip??

i never noticed it on mine...

[dynamite]

o yeah and where can i find a lip to buy?

[WI_Zoe]

yeah the Ex's came with a lip stock but the junkyard might have a lip

[Bruce Banner]

Do I need to take off the bumper to put this on?

[King James]

Do I need to take off the bumper to put this on?

its not necessary....but it makes the job 10x easier.

And like other ppl said just use some self-tapping screws....Use more along the bends as those will take a bit more work to make it fit right....You can also use a hair dryer to warm up the plastic to make the job even easier....Although that definatly isnt a necessary thing.