I then lined up the 9.75cm and the 8.5 cm and put a dot in the center of where they met. I took the template I made and lined it up to where the center of the bulb inside would be in relation to the sidemarker since those measurements are where the center of the bulb is.
Looking at that paragraph, I would say you measure up 9.75 cm from the molding, then from the door jamb, you measure in 8.5 cm. Then make a dot there. Looking at the back of the side marker, figure out where the light socket is in retrospect to the template, take that spot, and put it on the dot on the fender. Tape the template to the fender, trace and cut accordingly
Looking at that paragraph, I would say you measure up 9.75 cm from the molding, then from the door jamb, you measure in 8.5 cm. Then make a dot there. Looking at the back of the side marker, figure out where the light socket is in retrospect to the template, take that spot, and put it on the dot on the fender. Tape the template to the fender, trace and cut accordingly
Comment