how to take apart altzzea tail lights

[charlie0882004]

Is there a way to take them apart?

[iwork4mycb7]

wat u mean? take em out the car ? or make em in small pices?

[charlie0882004]

Take them apart as in taking the plastic glass off the housing . I want to paint the sliver part.

[GangGreenGang]

Sure.........you can put them in the over for about 2-3 minutes at about 350 and I STRESS: "!Do this at YOUR OWN RISK! I'm not responsible for your stuff melting." Once you take it out the glue that holds them together should be loose enough to pull it apart.

[cb95spd]

hair dryer works better or heat gun

blow the hot air at the seals until you can gently pry it off

[F20A CB7]

Sure.........you can put them in the over for about 2-3 minutes at about 350 and I STRESS: "!Do this at YOUR OWN RISK! I'm not responsible for your stuff melting." Once you take it out the glue that holds them together should be loose enough to pull it apart.

Ya wat he said ^^^

Gently take apart the lights tho, do not rush u don't wanna crack the housin or better yet the tail light cover.

[C91BLX7]

350ºF is way too hot. Your begin to melt the housing an lenses at that temp.

[TypeG]

i think on those kind of tails, the outer lamps are put together with a sealant similar to the OEM tails, but the trunk lights are melted together like bumper lights. i could be wrong, but it's def something to look out for.

also some people have had good luck seperating the tails with wd-40. you have to soak the seam for a day or so. later.