I thought that Sylvania 9005 were the low beams and 9006 the high. I just took my headlights out, and I got a 9006 on the outside (with the bulb cap) and 9005 on the inside, which I thought was low beam and high beam, respectively.
Did whoever replaced the bulbs on this car last put the bulbs in the wrong place? Is the one with the octagonal cover over it high or low?
Cheers.
Edit: When baking the light to break the seal/cure the paint, can you leave the hose for the water drain attached? I think it's sealed with silicon or something, cos it ain't comin' off... Baking temp is only 225 iirc, but I ain't sure how well the rubber would hold up to that.
Did whoever replaced the bulbs on this car last put the bulbs in the wrong place? Is the one with the octagonal cover over it high or low?
Cheers.
Edit: When baking the light to break the seal/cure the paint, can you leave the hose for the water drain attached? I think it's sealed with silicon or something, cos it ain't comin' off... Baking temp is only 225 iirc, but I ain't sure how well the rubber would hold up to that.
Comment