So I bent the subframe on my accord a while back. I'm dumb I know. Then I bought an e30 and it's a blast to drive and solid mechanically and what not but I miss my cb. Supposedly the subframe is a bitch to replace and not something I can do in my garage. I'm just kind of torn on what to do... especially because I leave for college very soon. But I need to sell one of the cars and at this point I'd rather sell the BMW. But I dont' know if it's realistic that I can get my subframe replaced... sorry I've just been thinking about this constantly and was seeing if there were some opinions or some help with the subframe?
Announcement
Collapse
No announcement yet.
What to do with my car...
Collapse
X
-
as long as the main chassis frame isn't bent the subframe is replaceable without too much issue, the tension rods on the sides are a bitch to get on by yourself so i would advise you to grab a buddy to help.Retired 1990 Accord LX Coupe
Project 240SX
Originally posted by chillin943anyone kno if i can just make a hot wire for v-tec off the horn??
Comment
-
Originally posted by F22HB View PostWe should have a meet and help him fix his subframe.
I bought this beamer but I miss my accord so much. I went to a junk yard hoping to find a subframe I could try pulling off but I couldn't find one.
So the engine will hold itself up with out the rear mount?
Comment
-
Hopefully. I'm not really sure, I was going to just go at it this weekend but ended up not starting because I couldn't find a subframe and heard I needed to hold the motor up. Any ideas where I could find a subframe? I don't have much money to spend on this right now since I currently own both cars.
Comment
-
only mount you need to loosen is the front one. put the front of the car on jack stands. use a jack and a block of wood on the edge of the tranny casing or wherever you see fit and put some pressure on that bitch to loosen the mount up and get that top bolt out. after that its all about the big long bolts in the bottom of the frame and the tension rod bolts on the knuckles. watch out, they have a lot of pressure on them.Retired 1990 Accord LX Coupe
Project 240SX
Originally posted by chillin943anyone kno if i can just make a hot wire for v-tec off the horn??
Comment
-
Originally posted by ilovemycb7 View PostI dont' know of any other good junk yards, I only know of south end auto which is big but not the best. Where are you at? Or where is the junk yard you speak of at?
Comment
Comment