Nor*Cal what did you do to your car recently?

[cali-racer]

I'll try to drop by sometime nextweek.

lmk when!

[ExplodingCake]

Mainly this coming saturday.

[cali-racer]

Mainly this coming saturday.

koo shit.. i supposed to be heading out to san jo like late afternoon, possible early evening. dunno yet.

[jdm_inspired]

thanks to 2 homies that came threw and help. yall know who u are

Nice!

[wed3k]

thanks to 2 homies that came threw and help. yall know who u are

cool beans.

[cali-racer]

gracias.

just gotta do some minor shit n it should be good to go.

edit: i gotta lower ball joint problem. i've notice that the left lower ball joint was replaced by the previous owner, looks after market cuz it has no holes for the cotter pin and the nut size is a 18. when i was screwing the nut on, i notice the stud was spinning. the nut is not all the way on, no matter how i do it, the stud still spins. any suggestions?!

[wed3k]

push the spindle down so the tapered part of the BJ is pressed against the control arm.

[jdm_inspired]

gracias.

just gotta do some minor shit n it should be good to go.

edit: i gotta lower ball joint problem. i've notice that the left lower ball joint was replaced by the previous owner, looks after market cuz it has no holes for the cotter pin and the nut size is a 18. when i was screwing the nut on, i notice the stud was spinning. the nut is not all the way on, no matter how i do it, the stud still spins. any suggestions?!

Use a impact gun. Worked for me.

[FuncOvrForm]

Eric. You wont.

[samrjr0044]

Picking up jdm f22a tomorrow. Should be in by wednesday. Will be picking up another to start building.

[cali-racer]

push the spindle down so the tapered part of the BJ is pressed against the control arm.

ive tried that, ill try again.

Use a impact gun. Worked for me.

it'll probably still spin but ill try.

someone said just to replace it. but iono.

[cali-racer]

Eric. You wont.

hhhhmmmm .. if i had a clear box battery

[cali-racer]

wes - what ya used to plug the steering rack? i found out that the 2 bigger holes is like an 18 n the other a 20 or something. i plugged the smaller ones with a 17.

[wed3k]

17? like the head size fora bolt? i just cut the existing lines and looped them by the rack.

check the bj castle nut. if the threads are fucked, then it will def just spin the stud on the BJ. check if the part of the castle nut is bent inwards which i did one time trying to hit the control arm to make the BJ to seperate.

[jdm_inspired]

ive tried that, ill try again.



it'll probably still spin but ill try.

someone said just to replace it. but iono.

It worked for me. Twice.