Nor*Cal what did you do to your car recently?

[jdm_inspired]

Big day today....results will be posted later 2nite.

This morning Royal Purple 10w-30 oil change, new iridium plugs, cleaned out throttle body.

Later today:

Neptune RTP board with P72 tuned
Neptune RTP Tunerview setup
Innovate Wideband LC-1 install
AEBS high flow fuel rail

Test drive day?
You'll definately eat me alive now. If not, stick your head in the toilet.

[Warudakumi]

results?

3hrs if tuning on the dyno, Jei was able to squeeze 178hp/149trq

Jei said I couldve easily been 180 maybe a little more if I didn't have such a restrictive cat. Right now I'm going to see if I can break close to 185-90ish with lots of tuning and simple boltons without changing the internals. Next couple of mods will be a 78mm tb, pulsar spark plugs,Blacktrax port matched intake manifold and stacker plate, exhaust cutout and 3inch custom piping(yes 3 on n/a) seen great results with the prelude guys even on a otherwise stock motor.

[jdm_inspired]

3hrs if tuning on the dyno, Jei was able to squeeze 178hp/149trq

Jei said I couldve easily been 180 maybe a little more if I didn't have such a restrictive cat. Right now I'm going to see if I can break close to 185-90ish with lots of tuning and simple boltons without changing the internals. Next couple of mods will be a 78mm tb, pulsar spark plugs,Blacktrax port matched intake manifold and stacker plate, exhaust cutout and 3inch custom piping(yes 3 on n/a) seen great results with the prelude guys even on a otherwise stock motor.

Money-hungry beast. I can't keep up with your mods dude. Seriously.

[jdm_inspired]

Anyone want to buy an Optima Red top? It's sitting in my garage collecting dust. I switched to a Braille race battery and I only had this battery for a good eh...3-4 months maybe. I replaced the other Red top awhile back.

Want $50 picked up. Everything is fine. I have a voltage meter to test apon purchase.

Normally go for 110-120 new.

[BB6-SH]

3hrs if tuning on the dyno, Jei was able to squeeze 178hp/149trq

Jei said I couldve easily been 180 maybe a little more if I didn't have such a restrictive cat. Right now I'm going to see if I can break close to 185-90ish with lots of tuning and simple boltons without changing the internals. Next couple of mods will be a 78mm tb, pulsar spark plugs,Blacktrax port matched intake manifold and stacker plate, exhaust cutout and 3inch custom piping(yes 3 on n/a) seen great results with the prelude guys even on a otherwise stock motor.

Nice man, thats more than what I made with stage 1 cams. What bolt-on's do you have right now? 3in piping is the way to go now, seen a few dyno's with great results over on preludepower.com. Too bad i can't use something other than an afc.

[wed3k]

3hrs if tuning on the dyno, Jei was able to squeeze 178hp/149trq

Jei said I couldve easily been 180 maybe a little more if I didn't have such a restrictive cat. Right now I'm going to see if I can break close to 185-90ish with lots of tuning and simple boltons without changing the internals. Next couple of mods will be a 78mm tb, pulsar spark plugs,Blacktrax port matched intake manifold and stacker plate, exhaust cutout and 3inch custom piping(yes 3 on n/a) seen great results with the prelude guys even on a otherwise stock motor.

id roll with a 3" exhaust as well, anything after the cat is a restriction for hp anyways.

[BB6-SH]

My header came in today, resembles the mugen in the design.

[jdm_inspired]

My header came in today, resembles the mugen in the design.

What gift did Craig give you?

[BB6-SH]

What gift did Craig give you?

Fgk like the one you got, but not as mint. You put yours in yet?

[jdm_inspired]

Fgk like the one you got, but not as mint. You put yours in yet?

Haha no... taking my time.

[BB6-SH]

Haha no... taking my time.

I need to buy some flanges, o2 bungs and flex pipe, so i can take it off. Im going to have to drive to the muffler shop with the o2 sensor disconnected.

[wed3k]

exercised my springs tonight, hit up halfmoon bay but didnt push it hard. techno was playing and my dumbass forgot i drank two beers too.

Anyone want to buy an Optima Red top? It's sitting in my garage collecting dust. I switched to a Braille race battery and I only had this battery for a good eh...3-4 months maybe. I replaced the other Red top awhile back.

Want $50 picked up. Everything is fine. I have a voltage meter to test apon purchase.

Normally go for 110-120 new.

this is very tempting

[Warudakumi]

Money-hungry beast. I can't keep up with your mods dude. Seriously.

That's coz ur buyin phones and rims all the time!

This p06 is looking for a phuck buddy..... I believe it wants to do the dirty with a certain LSD h22a cb6 and fly to Neptune and back! Talk to mrx to see if he can socket and chip it. I'll give u my map as a base since we basically have the same exact mods. Help me sell my rims and vafc2 setup so we can hook ur car up.

[Warudakumi]

exercised my springs tonight, hit up halfmoon bay but didnt push it hard. techno was playing and my dumbass forgot i drank two beers too.



this is very tempting

Dew it! Seen it in person numerous times, still brand new.

[Warudakumi]

Nice man, thats more than what I made with stage 1 cams. What bolt-on's do you have right now? 3in piping is the way to go now, seen a few dyno's with great results over on preludepower.com. Too bad i can't use something other than an afc.

Dude ditch the vafc2! Can u run a obd2-->obd1 harness and plug in a obd1 ecu? With stage 1 cams u could be making more power but the vafc can't really fine tune.