Nor*Cal what did you do to your car recently?

[FuncOvrForm]

Now that the suspension squeak is eliminated.

I just need to find out why my wheel is still shaking a little bit above 50MPH.

Tires are balanced and has an even wear , new brake rotors, new tie-rods , new UCA and new lower BJ.

Worst case scenario it's the steering rack.

Wheel bearing?

[ExplodingCake]

Wheel bearing?

I forgot to mention they're new also.

I suspect it's my axels.

[H23 Lude]

just ordered new vents, and next month i will be ordering my skunk2 cam gears and then a tune.

[StockAccord]

Bought JDM 1 piece for the camry. Hopefully that guy can get me some jdm fenders.

[cali-racer]

how much of a pain in the ass would these be to put in?



better view, had to squeezed that in there. i havint touch this car in over a month, ive been neglecting it.

[ikayto]

it's a pain in the ass if you dont have a press and a torch.

:]

[cali-racer]

^
shiet! well, since i need my front slotted rotors to be put on, rather have them do those bushings at the same time as well.

[ExplodingCake]

^
shiet! well, since i need my front slotted rotors to be put on, rather have them do those bushings at the same time as well.

CD5 lip? got one?

[ikayto]

^
shiet! well, since i need my front slotted rotors to be put on, rather have them do those bushings at the same time as well.

a normal shop will probably charge a lot to do all your bushings.

[CB710AE]

[IMG]

daamm!!!!!!!!!!....your car is too low...

[ExplodingCake]

daamm!!!!!!!!!!....your car is too low...

He's never low.

[wed3k]

how much of a pain in the ass would these be to put in?



better view, had to squeezed that in there. i havint touch this car in over a month, ive been neglecting it.

just rip everything apart and ggive them to me, ive done it all before.

[cali-racer]

CD5 lip? got one?

sitting in the garage.

a normal shop will probably charge a lot to do all your bushings.

shiet.

daamm!!!!!!!!!!....your car is too low...

never too low.

He's never low.

[cali-racer]

just rip everything apart and ggive them to me, ive done it all before.

whats the only thing that needs to be pressed in? lower control arm is one..and what else? if soo, then i'll take what needs to be off.

sway bar end links aint that hard to put on and i know a few others. im getting different upper control arms with poly bushings already installed. i know some of the bushings im not gonna use, so i'll have some lefted over if u want em.

[wed3k]

whats the only thing that needs to be pressed in? lower control arm is one..and what else? if soo, then i'll take what needs to be off.

sway bar end links aint that hard to put on and i know a few others. im getting different upper control arms with poly bushings already installed. i know some of the bushings im not gonna use, so i'll have some lefted over if u want em.

just the lwoer control arm. you going to do the rear trailing arms? i want to get spherical bearings from hardrace. maybe we can get a couple orders going to save on shipping?