Finally after 4 years of waiting to be a little faster than I am now, I got my delta 272 cam installed and got a tune. After the tune I produced 127hp and 122tq. This is on a 230k mile engine (healthy) and auto tranny. I have to say I put down some damn good numbers....I havent even got my intake manifold setup on yet. Here is my dyno vid:
I raced a D-series EF hatch with lw flywheel and I pretty much walked really slowly away from a 50 roll and he nailed my ass on a 20 and 25 roll. If it was a 30 roll I might would have had a chance. I also rolled on a 2001 Integra bone stock by about a car. Not too bad for a wagon huh?
Edit: Found out that dyno reads waaayyy low. So probably pushing around abouts 135-145?
Edit #2: Mods:
SRI
Ractive header
2 1/4" straight pipe no cat
Delta 272 with AEM gear set 3deg advanced
I raced a D-series EF hatch with lw flywheel and I pretty much walked really slowly away from a 50 roll and he nailed my ass on a 20 and 25 roll. If it was a 30 roll I might would have had a chance. I also rolled on a 2001 Integra bone stock by about a car. Not too bad for a wagon huh?
Edit: Found out that dyno reads waaayyy low. So probably pushing around abouts 135-145?
Edit #2: Mods:
SRI
Ractive header
2 1/4" straight pipe no cat
Delta 272 with AEM gear set 3deg advanced
Comment