bb6 h22 dyno graph

[DrLove'sKuDang]

I'll get one up when i get home. I didn't dyno before the mods at all. U had a header and high flow cat as i recall. How much of an improvement did u notice when u modified your dc header?

it was a dc header, not much of a mod and when i had it tuned, it was before the collector mod. and i believe i did have a catco cat at the time, not sure though. honestly, i dont remember feeling any difference with the header mod, and i never had it retuned.

[BB6-SH]

it was a dc header, not much of a mod and when i had it tuned, it was before the collector mod. and i believe i did have a catco cat at the time, not sure though. honestly, i dont remember feeling any difference with the header mod, and i never had it retuned.

i couldn't find the a/f graph, it's hard to find a good header for the h22 that doesn't cost +800.

[japspecb7]

thats some sorry ass numbers

[foamypirate]

thats some sorry ass numbers

And that is a sorry ass post. Nobody asked for your criticism, so shut the hell up.

[BB6-SH]

And that is a sorry ass post. Nobody asked for your criticism, so shut the hell up.

thank you foamypirate , it doesn't matter what he says obviously he didn't read the whole thread.

thats some sorry ass numbers

You should read before you post. peak numbers aren't everything.

[BB6-SH]

Updated the first post with my new results.

[gloryaccordy]

Ah good stuff

*wipes brow*

[4GAccordH22]

In my experience, the DynaPak that BlackTrax uses reads quite low. I've had my car dyno'ed on a Mustang Dyno (Stock H22A1/USDM P13, header, Accord AEM CAI and 2.25 exhaust. Read 183hp/153tq), on a DynoJet (same setup, added P28 with Hondata S300, after tune it read 175hp/153tq and felt stronger than first dyno run on the butt dyno) and on BlackTrax DynaPak (Same setup, new tune read 171hp/153tq and felt even stronger!) and again on BlackTrax DynaPak (Prelude AEM CAI, new OEM injectors, BlackTrax IM spacer, H2U5 Accord EX tranny, Mugen low temp thermostat and fan switch and full P72/S300 tune. Read 170hp/149tq). I'll admit that my car MAY have Type S cams (they were in the motor when I got it along with the type s pistons that I had to put back to stock to pass smog).

So, yeah, DynaPak reads lower than other dynos.

[rexload]

Congrats, the Stage1 cams gave you a nice gain,

Do you have the IMS under or above your IAB?

[BB6-SH]

Congrats, the Stage1 cams gave you a nice gain,

Do you have the IMS under or above your IAB?

Thanks, i have the IMS under the IAB's.

[BB6-SH]

Alrite dyno'd today again, Now i have some issues with vtec kicking in and out.

[wrichards2005]

Sounds like the vtec solenoid.

[BB6-SH]

Figured out the problem, car is set to go again. Need to set up another Tuning session.

[BB6-SH]

i will be getting the lude dyno'd again this upcoming wednesday, i should see alot better midrange and maybe some better topend.

[BB6-SH]

new dyno up top, my last one too for now.