Announcement

Collapse

Please DO NOT Post In The General Section

From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.


The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.


For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.


Everyone will get a couple of warnings from here on out, after that I just start deleting threads.

Again if you have any questions, PM me or one of the other mods.
See more
See less

Block Sleeving

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #31
    Paid $860 for Golden Eagle to sleeve and bore and hone thru a vendor that was doing a group buy on honda-tech.com awhile back.
    Carlos
    My Members Ride Page

    Comment


      #32
      I got my quote from camp1320. GE HD sleeves and honed to my pistons comes up to $1081 shipped back to me.

      Comment


        #33
        that sounds about right.
        www.roskoracing.com << Euro-R manifolds/adapters and H22 parts

        >>check out my H23vtec build thread...
        http://www.honda-tech.com/zerothread?id=2030543

        Comment

        Working...
        X